How To Set Sag On Dirt Bike?

To change the sag, use a long punch and a large hammer to loosen the spring locking nut on the shock. 4. Then, turn the spring with your hand to adjust the rear spring preload. Make sure that when you’re turning the spring, the preload nut is also turning.

What should your sag be on a dirt bike?

The correct amount is approximately 33% of the bikes total available travel, usually between 95-115mm on full size bikes. The correct amount varies because of bike geometry, rider preference, and type of riding. The rider sag should be set with the rider in full gear.

How can I improve my SAG?

To change the sag, use a long punch and a large hammer to loosen the spring locking nut on the shock. 4. Then, turn the spring with your hand to adjust the rear spring preload. Make sure that when you’re turning the spring, the preload nut is also turning.

How important is setting sag on dirt bike?

The sag on your motorcycle plays a key role in the balance and stability of your bike. When testing different sag heights for your weight, riding style and riding conditions, the ideal setting for you will feel stable while going down fast straightaways and also comfortable and easy to turn when coming into corners.

You might be interested:  How Many Calories Burned Stationary Bike? (Solution found)

Why is setting sag important?

sag sets your absolute vertical position along the travel stroke of the suspension. if your sag is set so that just sitting on the bike you are already bottoming out the suspension, then if you hit the slightest bump you will run out of suspension travel and the bump will not be absorbed.

How much sag is trail riding?

The amount of recommended sag will vary depending on the type of bike that you ride. Typically, enduro/trail bikes fall between 25% – 35% recommended sag, while downhill bikes can be up to 40% recommended sag.

How much sag should you run?

Traditionally, it was often said that you should run about 25% sag for cross-country and about 30% for everything else. But modern bikes generally have more progressive linkages and radically better air shocks with volume spacers to control bottom-out.

What is sag setting?

Rider sag is the measurement of how much the forks and shock compress when you get on the bike. Setting the sag lets you change where in the range your suspension ‘sits’ with you on board, and it gives the suspension an initial point to work in either direction.

What does sag mean in biking?

If you are a bicyclist, SAG stands for support and gear. During a race, a SAG vehicle will be a welcome sight as you fatigue or encounter mechanical complications with your bike. If you are not a cyclist, you can support the athletes by volunteering to be a SAG driver.

How do I make my dirt bike suspension stiffer?

You can make your suspension stiffer by:

  1. Increasing spring rate: stiffer springs.
  2. Slowing down the compression or rebound damping: turning the clickers in.
  3. Using heavier weight fork/shock oil.
  4. Add more fork oil (see caution below)
  5. Changing internal valving.
You might be interested:  How To Measure Trek Road Bike Frame For Size?

How do I make my dirt bike suspension softer?

There is no correct measurement. To adjust your sag, you will need a hammer and punch, or a specialty tool offered by the manufacturer. After you loosen the shock spring lockring, turn the spring preload ring to increase or decrease sag. A general rule of thumb is that one complete turn changes the sag by about 3mm.

Should I lower my dirt bike?

Do not over lower you bike just so that you can touch the ground better. Yes, touching the ground is important but not as important as ground clearance. Ideally being able to touch with the balls of your feet is very comfortable but it all goes back to what type of riding you plan on doing.

Leave a Reply

Your email address will not be published. Required fields are marked *